Ultra Low cost PVC Mount Prototype.
total cost abt 50SGD
just need to find a way to lock the axis ether with clamps or just just plain knobs driven into the "T" joint.
DIY Alt-Azi Mount
DIY Alt-Azi Mount
You do not have the required permissions to view the files attached to this post.
perspective
this is a shot with a CD if u need a perspective view of the size
scope is mounted on the side with the Din rails.
here's a list of items u need to make your own.
1x 32mm PVC "T" connector
4x PG29 Cable glands
4x 6201 bearings
8-10x M12 nuts
2x 1 foot 12mm threaded rods
anyway u can easily change the size of the mount depending on the size of the bearings that you use.
scope is mounted on the side with the Din rails.
here's a list of items u need to make your own.
1x 32mm PVC "T" connector
4x PG29 Cable glands
4x 6201 bearings
8-10x M12 nuts
2x 1 foot 12mm threaded rods
anyway u can easily change the size of the mount depending on the size of the bearings that you use.
You do not have the required permissions to view the files attached to this post.
well you can either get them at RS(www.rssingapore.com) which is kinda expensive or u can get them at some hardware shop in simlim tower
i got mine in malaysia which cost abt RM8.20 each.
this is the exact model that i got from FAG
6201RSR
i got mine in malaysia which cost abt RM8.20 each.
this is the exact model that i got from FAG
6201RSR
mount with scope
Here's a pic with my scope,had to use a vice to clamp it since i dont have a tripod in my office.
You do not have the required permissions to view the files attached to this post.
- qu1xs1lv3r
- Posts: 188
- Joined: Mon Jul 11, 2005 4:06 pm
- Location: singapore
- Contact: