Page 1 of 1
WTS: AstroSlew II Alt-Az mount (SOLD)
Posted: Wed May 27, 2009 12:13 pm
by weixing
Hi,
May want to sell my AstroSlew II mount head... a very solid mount.
PM me if interested. Below are some photo of the mount.
Thanks for looking and have a nice day.
Posted: Wed May 27, 2009 1:13 pm
by hunguptodry
can put this on an aluminium surveyor tripod?
any adapter required to do this?
Posted: Wed May 27, 2009 1:25 pm
by weixing
Hi,
The mount bottom screw is standard tripod thread... 3/8". Not sure about the size of the surveyor tripod, but I think is different and you just need to get a replacement screw for it. I never use a surveyor tripod before but a lots of our member had done that.
Check out this link:
http://www.singastro.org/viewtopic.php?t=6295
Have a nice day.
Posted: Wed May 27, 2009 10:22 pm
by weixing
Hi,
The mount had been reserve at the moment.
Thanks for looking and have a nice day.
Posted: Thu May 28, 2009 9:29 am
by wucheeyiun
This is a good mount
...
Posted: Thu May 28, 2009 10:48 am
by rlow
The mount bottom screw is standard tripod thread... 3/8". Not sure about the size of the surveyor tripod, but I think is different and you just need to get a replacement screw for it. I never use a surveyor tripod before but a lots of our member had done that.
Fyi, surveyor tripod uses 5/8" screw while our Astroslew mount uses 3/8" screw treads. There are two ways to resolve this: either replace the 5/8" screw with a 3/8" screw (which I had done for my surveyor tripod) or buy a 3/8" to 5/8" adaptor (Manfrotto etc) to fit into the Astroslew mount.