I need to drill some holes on my CF tubes, prefer not to do it myself since it's quite hazardous and i need a special drill bits for it. Anyone knows where I can go for some simple carbon fiber machining here?
thanks,
Arief
Where to go for Carbon Fiber Machining?
- HoO_Germany
- Vendor
- Posts: 107
- Joined: Sat Mar 04, 2006 8:41 pm
- Location: Heinsberg
- Contact:
Hi arief
wich diameter shall have the aluminium rings?
I have some rings could be machined in diameter between 160 and 200 mm inside. Max diameter outside is 215 mm.
Clear skys
Robert
wich diameter shall have the aluminium rings?
I have some rings could be machined in diameter between 160 and 200 mm inside. Max diameter outside is 215 mm.
Clear skys
Robert
House of Optics Germany
Intes-Micro/Ylena/STF/LOMO/Synta
www.hoo-germany.de
e-mail: info(@)hoo-germany.de
Tel.: +49 2452 976144
Intes-Micro/Ylena/STF/LOMO/Synta
www.hoo-germany.de
e-mail: info(@)hoo-germany.de
Tel.: +49 2452 976144
- HoO_Germany
- Vendor
- Posts: 107
- Joined: Sat Mar 04, 2006 8:41 pm
- Location: Heinsberg
- Contact:
Hi arief
I understand. But if you will build inside these rings, your apperture will be smaller. So maybe it will be better to use some rings, you can mount outside the tube, to make it also rigid, or you must get someones are really small.
A friend had the same problem at his Newton, and he took some wood-rings and mount them outside the tube.
Clear skys
Robert
I understand. But if you will build inside these rings, your apperture will be smaller. So maybe it will be better to use some rings, you can mount outside the tube, to make it also rigid, or you must get someones are really small.
A friend had the same problem at his Newton, and he took some wood-rings and mount them outside the tube.
Clear skys
Robert
House of Optics Germany
Intes-Micro/Ylena/STF/LOMO/Synta
www.hoo-germany.de
e-mail: info(@)hoo-germany.de
Tel.: +49 2452 976144
Intes-Micro/Ylena/STF/LOMO/Synta
www.hoo-germany.de
e-mail: info(@)hoo-germany.de
Tel.: +49 2452 976144